I made very little progress this weekend but I did get to break out the Douglas Fir. The Douglas is stored underneath the jig so I had to knock off the dust. I did not do a very good job as you can tell.
I started to cut out the doublers for the Transom. I was able to get the top and bottom doublers cut but ran out of time for the sides....
I had been using the thinner Bosch T101AO blade up to this point but had to switch to the T101B for the thicker cuts. I was getting a lot of waviness on the cutting surface with the thinner blade. I tried changing the feed and blade speed but it did not help. I changed to the thicker T101B and the cuts were nice and smooth.
